(7) na het beëindigen van alle stro

(7) na het beëindigen van alle stropdas staven vastmaken aan 60 N･m, terug naar de eerste paar stropdas staven om hen maximaal 90 N･m koppel. Fast Tie staaf tot derde regel op stang met Magneethouder uit het gat van de magneet plaat komt. Festinating herhalen op andere stropdas staven. Het koppel van de staaf stropdas zullen ongeveer 90 N･m.
(8) ten slotte recheck als alle stropdas staven koppel worden bereikt om 90 N･m door momentsleutel.
In geval van zware lekkage uit de electrolyzer, zet vast de stropdas staven tot 110 N･m.

結果 (英語) 1:

(7) after finishing all tie rods attach to 60 N ･ m, back to the first few tie rods to them up to 90 ･ N m of torque. Fast Tie rod to third line on rod with magnet holder out of the hole of the magnet plate. Repeat on other Festinating tie rods. The couple tie rod will be approximately 90 N ･ m.(8) Finally, recheck if all tie rods torque be reached to 90 N ･ m by torque wrench.In case of heavy leakage from the electrolyzer, fasten the tie rods to 110 N ･ m.

結果 (英語) 2:

(7) after finishing all tie rods attach to 60 N · m, back to the first few bars to tie them up to 90 N · m of torque. Fast tie rod to the third line on rod with magnetic holder comes out of the hole of the magnetic plate. Festina Ting repeat bars on another tie. The torque of the rod tie will be approximately 90 N · m.
(8) Finally, recheck if all tie achieve rods torque to 90 N · m by torque wrench.
In case of heavy leakage from the electrolyzer, fasten support the tie to 110 N · m.

結果 (英語) 3:

(7) after the end of the tie bars up to 60 n･m, back to the first few tie rods for up to 90 n･m couple. fast tie rod to third line up with magneethouder from the hole of the magnet plate. festinating repeat on other tie rods. the torque of the tie rod will be about 90 n･m.(8) finally, if all recheck tie rods couples reached to 90 n･m by torque wrench.in case of heavy leakage from the electrolyzer, put the tie rods to 110 n･m.