(7) Nadat u klaar bent met het beve

(7) Nadat u klaar bent met het bevestigen van alle trekstangen aan 60 N･m, ga terug naar de eerste set van trekstangen en geef deze maximaal 90 N･m. Maak de trekstang vast tot de derde lijn op de stang met de magneethouder uit het gat komt van de Magneetplaat. Herhaal de handelingen voor alle overige trekstangen in dezelfde volgorde.
(8) Controleer aan het einde of alle trekstangen zijn vastgemaakt met 90 N･m in koppels met de moersleutel. In geval van zware lekkage uit de electrolyzer, zet vast de stropdas staven tot 110 N-m.

結果 (英語) 1:

(7) after you have finished fixing all tie rods to 60 N ･ m, go back to the first set of tie rods and give it up to 90 N ･ m. create the tie rod until the third line on the rod with the magnet holder magnet comes out of the hole plate. Repeat operations for all other tie rods in the same order.(8) check at the end or all tie rods are fastened with 90 N ･ m in couples with the wrench. In case of heavy leakage from the electrolyzer, fasten the tie rods to 110 N-m.

結果 (英語) 2:

(7) After you have finished fixing all the tie rods to 60 N · m, go back to the first set of tie rods and give it up to 90 N · m. Take the rod fixed to the third line on the rod with the magnet holder from the hole comes from the Magnet Plate. Repeat the procedure for all other lower links in the same order.
(8) Check at the end of all tie rods are secured with 90 N · m in pairs with the wrench. In case of heavy leakage from the electrolyzer, fasten the tie rods to 110 Nm.

結果 (英語) 3:

(7) after you"re done with the confirm of the tie rods to 60 n･m, go back to the first set of tie rods and give this up to 90 n･m. make the tie rods to the third line on the bar with the magneethouder from the hole of the magneetplaat. repeat the steps for all other tie rods in the same order.(8) check at the end of the tie rods are attached with 90 n･m in couples with the wrench. in case of heavy leakage from the electrolyzer, put the tie rods to 110 n m.